~ Directions For Use:
Apply one dose (1 mL) of Regaine^® to the hair loss area of your scalp two times a day, preferably morning and night. Massage the solution/gel lightly onto your scalp, and wash your hands well afterwards. This dose should be used no matter what the size of the bald spot is. It has been shown that twice daily use of Regaine^® may be required for at least four months before you will see the evidence of cosmetically acceptable hair growth. Response to treatment with Regaine^® may vary widely, and some patients may see faster results than others.
.

~ How to apply Regaine^® solution

A. Pump Spray Applicator

1. This applicator works best for applying Regaine^® to large area of the scalp.
2. Remove large outer cap; remove small inner cap and discard it.
3. Insert the pump spray applicator into bottle and screw on firmly.
4. After aiming the pump toward the center of the bald area of the scalp, press the pump once and spread Regaine^® with fingertips to cover all of the bald area. Repeat for a total of 6 times, to apply a dose of 1 ml of solution. Avoid breathing spray mist. Place large outer cap on bottle when not in use.

B. Extended Spray-Tip Applicator

1. This applicator works best for applying Regaine^® to small areas of the scalp or under hair.
2. The pump spray applicator must be on the bottle to use the extended tip applicator. Follow steps A.2 and A.3.
3. Remove small spray head from top of pump spray applicator; fit the extended spray tip applicator onto the spray shaft and push down firmly. Remove the small cap on the end of the extended tip.
4. After aiming the applicator toward the center of the bald area of the scalp, press the pump once and spread Regaine^® with fingertips to cover all of the bald area. Repeat for a total of 6 times, to apply a dose of 1 ml of solution. Avoid breathing spray mist. If desired, replace the small cap on the end of the extended tip when not in use.
   
   

C. Rub-On Applicator

1. This applicator works best for applying Regaine^® to small areas of the scalp.
2. Remove large outer cap; remove small inner cap and discard it.
3. Insert the rub-on applicator into bottle and screw on firmly.
4. Holding the bottle upright, squeeze the bottle once to fill the upper chamber to the black line. The chamber now contains one full dose 1 ml of solution.
5. Holding the bottle upside down, rub the applicator on the scalp to cover all bald area, until the chamber is completely empty. Place large outer cap on bottle when not in use.